Relay Coordination Study and Analysis Service

In power system protection relay and circuit breakers is the major instrument for large interconnected power system. We need proper protection to isolate the faulted region from healthier network. When two protective apparatus installed in series have certain characteristics, which provide a specified operating sequence, they are said to be coordinated or selective. Relay coordination is an important aspect in the protection system design as coordination schemes must guarantee fast, selective, and reliable relay operation to isolate the power system faulted sections.

Why is Relay Coordination Study and Analysis Performed?

Relay coordination study and analysis is performed to make sure that safety operation of the system are functioning correctly and to avoid the nuisance tripping, as protection is a major concern in any industry and they rely on protective devices for the same. The reason for nuisance tripping is modification of protective devices and their settings at the time of upkeep without performing suitable study and analysis.

The aim of a coordination study is to determine the characteristics, ratings, and settings of overcurrent protective devices which will ensure that minimum unfaulty load is interrupted when protective devices isolate a fault or overload anywhere in the system. A coordination study should be conducted

• In the early planning stages of a new system to tentatively select protection and utilization equipment
• In the case where an existing system is modified and new loads are installed
• When existing equipment is replaced with higher rated equipment

What is Done During a Relay Coordination Study and Analysis?

ANSI / IEEE Std. 242 – 1986 (Recommended Practice for Protection and Coordination of Industrial and Commercial Power System) is the standard used for this study.

Mostly relay coordination study and analysis is computer aided. There are several computer programs available for the protection coordination analysis of power system applications. Such programs include short circuit analysis and device time current characteristics. The main purpose of the protective coordination software is to produce one-line diagrams, calculation of relay settings and time current coordination drawings. Software will contain features to model various protective devices, equipment damage curves and store the data for future use. Using the software, the device characteristics can be called from the library and used for the coordination studies.

• Personal computer – either stand alone or connected to a network with sufficient memory is needed for this type of application. Also, a good graphical monitor and laser quality printer is required. By performing the study on a personal computer, several alternatives can be examined before arriving at the final solution. The data can be stored in the computer for future use or verification of the calculations. The one-line drawings, TCC and the output can be printed for a report. Alternatively, these files can be copied and pasted in word processing documents.
• Graphical display – The one-line diagram of the electrical circuit and the device coordination curves can be displayed on the graphical monitor for demonstration. Such a display helps to identify the necessary corrections to be performed before getting a printout of the diagrams or graphs.
• One-line diagram – A one-line diagram of the electrical circuit for which the coordination is performed is always needed for report preparation. The software can be used to prepare the one-line diagram with the necessary devices shown. Such an approach eliminates the need to deal with the drawing office support for the protection study.
• Project data files – A database is a method of storing digital data. The database can be structured to store all the necessary device characteristics, short circuit data and coordination data. These programs can perform calculations of the inrush current, device settings and project details. The project data can be copied from one computer to another for analysis.
• Device library – These programs are equipped with a large library of data from various manufacturers. The library includes models for overcurrent relays, ground relays, static trip breakers, moulded case circuit breakers, data for cable damage curve, and data for transformer damage curve, motor overloads and reclosers.
• Interactive data entry – It is not always possible to have the data available from the device library for the selected study. If the data are not available and if the equation or graphical data are available, then the data can be entered interactively. The data points can be entered item by item and can be saved for future use.

How is Relay Coordination Study and Analysis Done?

One-Line Diagram

If the study is on a new system or already existing system, attain or create a one- line diagram of the system or the part of the system concerned. The dia.